pic
picture
Home>Quality Management >Product testing
Product testing
  1. Thermal Resistance Stability Test
    Measure the surface resistance (Ro) before baking and measure the relative value after baking (R) .
  2. Chemical Durability Test
    Measure the surface resistance first(R0). Put the sample into solvent baker guring defined time, clean the sample and measure the relative value of the surface resistance (R).
  3. ITO Adhesion Test
    Reference to ASTM D3359.
  4. Surface Hardness Test
    Reference to ASTM D3363.
  5. Thermal Shrinkage Rate
    According to ASTM D1204.
  6. Warpage Test
    According to ASTM D1204.
  7. High Temperature Test
    High-temperature environment is simulate the changes of product quality characteristics and accelerate the aging time.
  8. Low Temperature Test
    Simulating the characteristic change and aging result of products under the low temperature environment.
  9. Thermal Shock Test
    Simulating the plastic material physical characteristics durability under the quick change of high-low temperature.
  10. Scratching Test
    Simulating the end product using state to verify the damage state under thousands times repeat cycling pen type scratch on the hard-coat film.
  11. Wear-resisting
    Test Hardens parent metal of the membrane, places on the wear-resisting testing machine, after the fixed load capacity and the cyclical hypothesis, carries on the parent metal strengthening test.
  12. DYNE Test
    Rapidly and tests of surface tension accurately the coating whether to achieve test pen's value.
  13. Anti-UV Experiment
    Simulating the end product using at out-door to verify the physical characteristics change under the sun-shine .
  14. Water-absorptivity Test
    To coordinate customer system regulation and the product demand carry on the Film proportion and the absorbing water rate experiment
  15. Hazardous Substances Test
    Follow the regulation of official documents or customer's requirement .